SSB BackStay Antenna Wire Clamps

SSB BackStay Antenna Wire Clamps

You can order any size of clamp for the backstay antenna connection from e-Rigging.com

316SS Marine Grade 
3/32" to 3/4" sizes
$2-40 per clamp

Stainless Steel Wire Rope Clip - Type 316 cast s.s. for 1/2 in. wire rope. Wrench Size: 3/4 inch.

Termination Efficiency Rating: 80%




    • Related Articles

    • Icom M803 HF/SSB Recommended Ferrite Placement

      See the following diagram for locations of ferrites in a complete M803 installation, including optional Pactor modem. m803 noise suppression diagram

    • Is the Icom M803 Radio NTIA Certified

      At this time the M803 is not NTIA certified ​(per Icom, as of 11/11/2022)

    • Tech Note: M803/Pactor AirMail Settings

      These are the standard settings for successfully configuring Airmail to connect to a P4-Dragon Pactor modem and Icom M803 HF/SSB Radio. (Note your COM port may be different depending on your hardware) airmail settings

    • Tech Note: Icom M803 Pactor Modem Connections Update (April 2020)

      In communication with Icom, Sailmail, and Farallon Electronics, Sea-Tech Systems has updated the requirements for connecting a Pactor Modem to the new Icom M803 Marine HF/SSB Transceiver.   The change affects cabling requirements, as well as menu ...

    • Installing Starlink near Satellite TV

      For best results, KVH recommends 14ft separation between Starlink antenna and satellite TV receiving antenna. These recommendations apply to all satellite tv receiver antennas from Intellian and KVH when installed near a Starlink antenna. "When ...