Connecting Remote Switch to Starlink Power Kit Inverter
To power the inverter (and hence the Starlink) on and off as needed using the included panel switch, wire the switch to the "Remote" terminals on the Victron Phoenix Inverter. (remove the jumper wire that comes preinstalled)
Related Articles
Installing Starlink near Satellite TV
For best results, KVH recommends 14ft separation between Starlink antenna and satellite TV receiving antenna. These recommendations apply to all satellite tv receiver antennas from Intellian and KVH when installed near a Starlink antenna. "When ...Tech Note: Icom M803 Pactor Modem Connections Update (April 2020)
In communication with Icom, Sailmail, and Farallon Electronics, Sea-Tech Systems has updated the requirements for connecting a Pactor Modem to the new Icom M803 Marine HF/SSB Transceiver. The change affects cabling requirements, as well as menu ...Quick Start Guide: Sea-Tech WiFi Extender Package
Quick Start Guide for Sea-Tech Systems Wi-Fi Extender Kit Wi-Fi Extender Kit Contents: 2.4Ghz Only Kits: Wi-Fi Extender: Wave Wifi Rogue Reach or Rogue Pro POE Injector AC Power Adapter DC Power Adapter 25ft Ethernet cable (pre-attached on Rogue ...Installation Diagram: Sea-Tech Marine Cellular Booster Kit
Booster Kits with 30, 40, or 75ft Antenna Cables Booster Kits with Custom Antenna Cables Booster Kits with 20 or 40ft Antenna CablesConnecting PXdragon DR-9400 Modem to PC via USB-C
USB Interface To operate the DR-9400 modem like the old DR-7X00 modems over a virtual COM port via USB, you need to install a new SCS-USB driver. Note: For Windows 11 users this new driver also works with 7400/7800 series modems First, completely ...